TPI 319C 315 Pocket Digital Thermometer

TPI 319C 315 Pocket Digital Thermometer

Contact Tip

Field calibrate to ±2°F

Rugged and water resistant

Temperature range -58°F to 300°F

Easy-to-read LCD

Magnets clip perfect for air duct applications

319C Operating Instructions

To measure temperature with this unit follow these simple instructions:
Selecting Fahrenheit or Celsius mode:

• With the unit “OFF” press and continue to hold the ON/ OFF button.
• The LCD will alternate between °F and °C. Release the ON/OFF button when desired measurement mode appears on the LCD
• Remove the protective sheath from the stem.
• Press the ON/OFF button.
• Insert stem into area or object to be tested. At least 1/2” of the stem must be inserted.

Warning: The stem is a sharp and pointed object which can be dangerous.

The Data Hold function is used by pressing the D-H button when taking a measurement. The measurement will flash on the LCD when Data Hold is in use. To return to normal function, press and release the D-H button a second time.

Press the ON/OFF button to end operation, or the unit will automatically power off after 35 minutes.

To reverse the LCD to suit your viewing angle:

Insert a small coin into notch in curved area “B”, then gently pry portion “A” from “B”. Shielded wires will keep the two parts connected. Twist the area “A” 180° and snap back into area “B”.

Get more accurate readings by using the right tip for your thermometer:

• Penetration: Use for immersion and air; air response time will be slower than if using anactual air probe.
• Chisel: Need chisel tip for surface temperatures. Penetration and/or air tips will not givean accurate surface reading.
• Air: Samples air temperatures three times faster than penetration or contact tips.
• Contact: Measures three times faster than chisel tip.

Applications HVACR

• Ambient Air
• Calibrate Thermostats
• Vents
• Compressor Heads
• Registers

ELECTRICAL

• Motor Temperatures
• Transformer Temperatures