PCE Instruments PCE-RT 2200 – Material Roughness Tester (Up to 21 Parameters)

• Roughness parameters: Ra, Rq, Rsm, Rsk, Rz, Rt, Rp, Rv, Rc, Rmax, Ry (JIS), Rz (JIS), RP (ASME), Rpm (ASME ), Rv (ASME), R3z, R3zmax, Rz1max, Rmr (c), Rdc, Rmr
• Measuring ranges: Ra, Rq, Rc: 0.005 – 16 µm / Rsm: 5 – 1000 µm / Rsk: -1 – 1 / Rz, Rt, Rp, Rv, Rmax, Ry(JIS), Rz(JIS),RP(ASME), Rpm(ASME), Rv(ASME), R3z, R3zmax, Rz1max, Rdc: 0.02 … 200 µm Rmr(c), Rmr: 0 -100 %
• Probe: Diamond, 90° angled
• 3 different cut-off wavelengths
• Micro-USB interface for data transmission to a PC

Material Roughness Tester with 21 Measurement Principles

The portable and easy-to-use roughness tester with its large OLED display is particularly suitable for quick and precise measurements in the workshop or laboratory. This roughness meter uses a DSP chip for control and data processing at high speed and with low energy consumption. In addition, you have a large selection of measurement parameters for the roughness measuring device: Ra, Rq, Rsm, Rsk, Rz, Rt, Rp, Rv, Rc, Rmax, Ry (JIS), Rz (JIS), RP (ASME), Rpm (ASME ), Rv (ASME), R3z, R3zmax, Rz1max, Rmr (c), Rdc, Rmr.

The measurements are automatically stored in the internal memory of the roughness meter. The stored data can then be transferred to a PC via the micro-USB interface on the roughness measuring device and analyzed using the software. It is also possible to have the data displayed on the OLED display of the roughness measuring device after a measurement. Even the wave course can be shown on the display of the roughness meter.

It often happens that the contact surface of the test piece is too small for a roughness measuring device to position the roughness measuring device appropriately for a measurement. For such cases, a positioning adapter is included with this roughness measuring device. Thus, the roughness measuring device also enables measurements on small samples.