Fluke I430-FLX-TFII-12 6000 A Flexible AC Current Probe 30cm (12 inch)

Fluke I430-FLX-TFII-12 – 6000 A Flexible AC Current Probe 30cm (12 inch)

The I430-FLX-TFII-12 (the Probe or Product) is a flexible AC current probe for use with the Fluke 430 series I and II Power Quality Analyzers and other dedicated test tools. The i430-Flexi-TF-II is optimized for current measurement on thick and hard to reach conductors. Check the user documentation of your test tool for compatibility before you use this current sensor.
 

Symbols

The table below is a list of the symbols used on the Probe and in the instructions.

Instrument Compatibility

The i430-Flexi-TF-II series is used with the Fluke 430-series and Fluke 430-II series Power Quality Analyzers specifically or with other test tools that explicitly state compatibility. Refer to user documentation of the test tool for information about compatibility.

Maximum measurement range on all models is 6000 A.

Minimum measurement range on Fluke 433/434/435 is 30 A.

Unpack

These items are included in the shipment:

• i430-Flexi-TF-II Current Probe(s)
• Instructions (this paper)

Check the contents of the shipment for completeness. If something in the box is damaged or missing, contact your distributor or the nearest Fluke sales or service office.

How to Use the i430-Flexi-TF-II

1. Connect the BNC connector of the i430-Flexi-TF-II to the input on the Fluke 430 series Power Quality Analyzer.
2. Wear protective equipment or de-energize the circuit before you connect the flexible probe around the conductor.
3. Re-energize the circuit if not energized.
4. Center the conductor perpendicularly inside the flexible probe area. If this is not possible, an additional measurement error of ±2 % of reading can occur. See Electrical Specifications.
5. Avoid taking measurements close to other current-carrying conductors if possible.
6. Make sure that the arrow marked on the probe coupling points toward the correct orientation for correct phase display on the instrument. See also the setup screen of the instrument.
7. Keep the probe coupling more than 2.5 cm (1 inch) away from the conductor.
8. Observe the current value and waveform on the instrument display.
9. Observe the safety instructions when you connect and use the i430-Flexi-TF-II.
10. Wear protective equipment or de-energize the circuit before you disconnect the flexible probe.

If the i430-Flexi-TF-II does not work

If the Probe does not perform properly, use the following steps to help isolate the problem:

1. Inspect the coupling system for any damage. If any foreign material is present, the coupling system will not close properly and errors will result.
2. Inspect the cable between the flexible probe and the Power Quality Analyzer for any damage.
3. Check if the i430-Flexi-TF-II is the selected current probe on the Power Quality Analyzer (Clamp i430-Flexi-TF-II).
4. Verify that the function and range selection on the Power Quality Analyzer is correct.