Comet D3633 – Thermo-Hygrometer and Logger

• With Magnets
• Adjustable dual alarm with audio
• Indication for each channel
• Memory of minimum and maximum values
• Function Hold – manual storing of actual values for later displaying
• 3 logging modes with PC interface

Thermometer, hygrometer is designed for measurement and data logging of temperature, relative humidity into the internal non-volatile memory. Simultaneous reading of temperature and air relative humidity, dew point temperature reading selectable, built-in sensors. Surface temperature probe with attaching magnets on the instrument bottom. Indication of temperature difference of surface probe and dew point.

Instruments are designed for direct measurement and data logging to internal non-volatile memory in adjustable time intervals. Recorded data is possible to transfer by means of a free program via serial Rs232 link to a PC for archiving or analyzing. The instrument is connected to a PC by including a communication cable only for data transfer from the memory. During connection to the PC, neither measurement nor record is enabled. Instruments are designed for non-aggressive air measurement.

Record

Measured values can be stored in memory. Measured values are stored either automatically or manually. automatic record stores the values at pre-intervals from 10s to 24h. Logging mode can be adjusted as non-cyclic, when logging stops after filling the memory, or cyclic when the oldest recorded values are overwritten by new ones after the memory is full. You can store up to 16,000 Values. Manual mode allows you to save the current values by pressing HOLD / ENTER. Stored values can be transferred via the USB port to the PC.

Data Analysis

The Recorded data can be transferred to a PC for further analysis. Obtained values can be displayed in the form of a table or graph, data can be printed or exported to dbf or txt format for further processing of spreadsheet software.

Alarm Indication

For each measurement, the channel can be set upper and lower limits. In case the limits have exceeded these limits alarm is indicated as the value blinking on the display. If the alarm is activated, the device can draw attention to this fact also by an intermittent acoustic signal which can be turned off.