Mastercool 69500 – RECOVERYMATE Recycling Module (Compatible with R134A Refrigerant)

• Hoses are not included
• Recoverymate speeds up the recovery process by removing unwanted moisture and separating oil from the recovered refrigerants.
• Features a 4-way ball valve manifold, a large capacity oil separator, and a high-performance dryer to eliminate moisture.

Speed Up the Recovery Process! Remove unwanted moisture and separate oil from the Recovered Refrigerant. (Use with any Recovery Machine).

Draining Oil Separator

When recovering and recycling refrigerant most oil that is removed from the A/C system will be retained in the oil separator. The oil should be drained out of the separator after each use to prevent the mixing of different oils during recovery.

• After recovery / recycle operation, when a low residual pressure (5-10 PSI, .3-.7 bar) exists in the recovery/recycle unit, close “valves 10 and 11”. Put a small container under “valve 9”.
• With the oil separator standing vertically, very slowly open “valve 9”. Oil collected by the oil separator will drain into a container. Close “valve 9”. Dispose of oil in an approved manner.

Filter Maintenance

Filter should be changed on a regular basis. The frequency will depend on the condition of the refrigerants being recovered/recycle. One way to test for a dirty filter is to compare the pressure readings on the low side gauge of the manifold with the low side gauge recovery machine. With recovery/recycle system circulation refrigerant gauge readings should be within 10psi (.7 bar) of each other. A pressure difference higher than this indicates a dirty filter.

Moisture Indicating Sight Glass

The moisture indicating sight glass changes color depending on the amount of moisture present in the recycling system. As mentioned previously in recycling system should be kept sealed to prevent moisture from the outside of the system from contaminating indicating sight glass. Replacement of sight glass is required when recycle system is evacuated to a high vacuum and sight glass does not indict a “dry” condition.