Compliance Defib Surge P – Surge Tester, External Defib Protection w/IGBTs

• Generates the waveform required by EN 45502-1, Sec. 20, Para. 20.2
• Designed with operator safety in mind
• Theoretical graphs and actual graphs showing the output of your tester
• 10 ohm tap for proper measurement of the 140 volt pulse and a 300 ohm tap for delivery

The MegaPulse Defib Surge P is designed to conduct the test shown in EN 45502-1:1997 Para. 20.2, “Protection of the device from damage caused by external defibrillators”. In accordance with this Standard reference, the Defib Surge P is built to the schematic shown in EN 45502-1 Figure 1 using the circuit values shown in Para. 20.2. The output of the Defib Surge P is fixed at 140 volts peak, measured from the 10 ohm tap on the front panel, in accordance with the Standard. A front-panel switch reverses the output polarity which is required for proper testing. The output of the Defib Surge P can be measured with an oscilloscope using an appropriate 10X probe. There is no BNC oscilloscope output on the Defib Surge P. The 300 ohm tap on the front panel is used to connect the AIMD to the Defib Surge P.

The MegaPulse Defib Surge P uses IGBT switches to deliver a clean signal output.

The Tests contemplated in EN 45502 require 3 positive going pulses separated by 20 seconds; then after a 60 second pause, three negative going pulses separated by 20 seconds. The positive and negative pulses can be delivered manually using the front panel buttons, or the pulses can be set to operate under USB computer control using the TestMinder Megapulse option. All pulses are delivered to the AIMD from the 300 ohm tap.

MegaPulse Defib Surge P ships with cables, graphs of theoretical and actual waveforms, and a Calibration Certificate. One-year warranty. Options include 240V input voltage, a PLC Interface Relay Board and computer control via USB TestMinder MegaPulse.

Options:

• Option RI: PLC Interface Board
• Option TMM: TestMINDER automation software
• Option: 240V Mains power