Franklin Grid CGS3-12V M10 – CELLGUARD Wireless Sensor (Without Strap Resistance), 12 Volt, M10 terminals

• CELLGUARD Wireless Sensor (Without Strap Resistance), 12 Volt, M10
• 1x per jar/cell, includes (1) sensor, (1) wire harness (2) 2-tabbed terminals
• Sensors capture voltage, temperature, & conductance
• Mesh routing communication
• Quick, fully hot-swappable sensor and/or wiring harness

Ensure Uptime with Advanced 24/7 Remote Monitoring

Get remote access to the information you need to proactively maintain your stationary power systems and avoid costly downtime. With solid noise immunity, the CELLGUARD™ Wireless Battery Monitoring System is suited for applications including power utilities, data centers, telecommunications systems, and DC systems with filtered AC electrical ripple.

Installation cost and time are reduced with the system’s wireless communication capabilities which enable all hardware to communicate to the Base controller free of cabling.

Conductance-based monitoring technology provides the most accurate, efficient, and non-invasive method possible for monitoring a battery’s state of health.

Comprised of a Base Coordinator Unit (BCU) and single-battery sensor modules, the system provides both visual and digital battery state-of-health and is capable of monitoring up to 16 battery strings, up to 300 sensors per string, and up to 600 sensors per BCU (irrespective of how they are divided by strings).

The highly intuitive CONVERGE web interface enables rapid, confident installation, remote system monitoring, alarm threshold configuration, rock-solid reporting (including granular discharge data gathering), and critical over-the-air sensor firmware updates.

The CELLGUARD Wireless Battery Monitoring System is capable of monitoring up to 16 battery strings, with 300 batteries per string, and supports up to 600 sensors per BCU.

Connects to and is powered from the monitored battery, minimizing wiring, installation costs and maintenance. Monitoring capabilities include conductance, voltage, strap resistance and temperature for each mono-block/cell /jar. Compatible with VRLA and VLA batteries.

Manages battery sensor test activities, collects test data and communicates to Converge web interface via TCIP/IP, and is powered by the battery string voltage converter via battery string power. Supports MODBUS TCP/IP to integrate with building infrastructure.

Battery state-of-health is provided at the hardware level. Each sensor has three modes of LED notification to display the battery’s current status, allowing personnel to quickly pinpoint batteries that require attention.

Blinking Green

Indicates no issues with the battery.

Blinking Yellow

This indicates a warning that the battery readings are out of warning limits.

Blinking Red

Indicates an alarm that the battery readings are out of alarm limits.

Cutting-Edge Web Interface

The CONVERGE Web Interface that comes standard with all CELLGUARD Wireless Battery Monitoring Systems allows personnel to configure, update, and monitor an entire network remotely.