Myron L 5972LV Heavy Duty Rinse Tank Control System

Myron L 5972LV Heavy Duty Rinse Tank Control System Less the Valve (220V)

• Input power: 220 VAC
• Cuts water consumption up to 85%
• IP65/NEMA 4X Rating Water and Corrosion Resistant Enclosure
• 316 Stainless Steel Hardware
• Reliable Solid-State Electronics

Dual Range Heavy Duty Rinse Tank Control System dramatically reduces the amount of water used in continuous flow rinse tanks. At the same time, it automatically maintains optimum water purity, ensuring effective rinsing.

How It Works

The three parts of the CONTROLSTIK II System are easily installed. The CONTROLSTIK II (conductivity sensor) is set at a tolerable contamination level and submerged in the tank. Water cannot flow into the tank until drag-in from rinsed parts causes the contamination level in the tank to rise above the pre-set point. The CONTROLSTIK II (sensor) then signals the solenoid valve to open, adding fresh water. As soon as this fresh water dilutes the contamination to the tolerable pre-set level, the CONTROLSTIK II (sensor) closes the valve.

After installation, the Controlstik (sensor) is submerged in the rinse water. When contamination (dragin) accumulates beyond the point “safe” for good rinsing, the sensor automatically opens the Solenoid Valve. Fresh water flows into the tank, and as excessive contamination is diluted back to the “safe” level, the sensor closes the valve, limiting water use.

Rinse water usage shall be minimized by means of automatic conductivity control systems. They shall consist of a temperature compensated conductivity sensor, corrosion resistant one-inch solenoid valve, and transformer box which safely reduces line power to the sensor. Enclosure shall be fiberglass with heavy rubber gasket and 316 stainless steel. Circuitry shall be solid-state, and unaffected by changes in voltage. Setpoint adjustment shall be on sensor to minimize tampering. Rinse tank controls shall be Myron L Model 597 or approved equal.

Limited Warranty

Myron L® CONTROLSTIK II™ Systems have a Two (2) Year Limited Warranty. If this system fails to function normally, return the faulty unit or the system to the factory prepaid. If, in the opinion of the factory, failure was due to materials or workmanship, repair or replacement will be made without charge. A reasonable service charge will be made for diagnosis or repairs due to normal wear, abuse or tampering. Warranty is limited to the repair or replacement of the units of the CONTROLSTIK II System only. The Myron L® Company assumes no other responsibility or liability.