Tabor Electronics 9250 30MHz Differential / Dual-Channel Signal Amplifier

Tabor Electronics 9250 – 30MHz Differential / Dual-Channel Signal Amplifier

Tabor Electronics 9250 is a bench-top, 2U, half 19” rack size, fully metal case dual channel amplifier. It can be configured to be used as two, single-ended independent channels, or as a one input with two differential outputs. The amplifier case was designed to stack on top or below other Tabor products.

Input Characteristics

The inputs to the amplifiers be configured to match different source impedance such as 50Ω, 75Ω, or 1MΩ and the outputs can be configured to match different load impedances such as 50Ω, 75Ω, or 600Ω. There are three inputs for each channel.

Output Characteristics

The outputs are located on the front panel. There are two outputs, one for each channel. When the 9250 is configured as two separate amplifiers, the outputs generate amplified signals within the range of 40Vp-p into open circuit or 20Vp-p into matching load impedance. The bandwidth of the outputs is around 20MHz for large signals. Small signal bandwidth can reach 50MHz.

Instrument Configuration

The 9250 can be configured as a differential amplifier. In this case, the channel 2 input is disabled and channel 1 input is amplified and distributed differentially to both outputs. In this case, channel 1 output generates in-phase signal while channel 2 outputs an inverted signal that has exactly 180 phase offset to the normal output. Full amplitude and bandwidth is preserved when the 9250 operates in differential mode. The output impedance of the differential outputs is modified to 25Ω, 37.5Ω, or 300Ω for differential drive of 50Ω, 75Ω, or 600Ω loads. Using the differential mode, the 9250 does not sacrifice accuracy, nor does it sacrifice bandwidth.

Auxiliaries

The 9250 has two additional inputs for each channel allowing summation of two signals and providing an external control of DC level offset. These inputs are accessible from the rear panel only.