Desco Ion Bar – Airless and Air Assisted (Product Selection Tool)

Desco Ion Bar – Airless and Air Assisted (Product Selection Tool)

DESCO ion bars have been designed to effectively eliminate localized static charges that exist in the work area.

The Ion Bar System is a pulsed DC ionizer. The bar’s emitters have alternating polarities over the length of the bar. This design results in less ion recombination than when the same emitter is used to output both polarities.

This system meets the ANSI/ESD S20.20 required limit of less than ± 50 volts offset voltage (balance) tested in accordance with ANSI/ESD STM3.1. Per S20.20 Discharge Time, required limits are “user-defined”.

Important notes on operation:

• Ion bars must be used with an HV controller, the DESCO 50855 is recommended (sold separately)
• Air assisted models to require connection to clean, dry compressed air (compressed air system not included)

Several sizes available

DESCO ion bars are available in several sizes, and in the airless or air-assisted format. The charts below provide an overview of each. Please see the documents section on this page for more detailed diagrams and dimensional information.

Discharge times

These measurements are taken with a Charged Plate Monitor placed below two consecutive emitters. The pulsing rate is adjustable from 1 to 20 Hz and will need to be customized depending on application requirements. Values will vary with the environment and particular application.

Non-air assisted

Air assisted

Ion bar controllers

DESCO ion bars require a controller to operate (sold separately) – the 50855 is recommended.

The 50940 is a basic controller with recessed potentiometer adjustment. It enables two adjustments – balance (offset voltage) and rate.

The 50855 is a more robust device with control buttons, a digital screen, RS-485 input, and more.

The chart below provides an overview of the main features of both controllers.